News

Dual durometer rubber profiles

Dual durometer rubber profiles are extrusions with different areas of hardness. Typically, the harder rubber is used for attachment while the softer rubber is used for sealing. By joining two materials of different physical properties, structural integrity and flexible function can be combined into one part. For example, when a rubber gasket must be [...]

May 28th, 2020|

Chloroprene Rubber (CR)

Chloroprene Rubber (CR) is a synthetic rubber that is also known by the trade name Neoprene. CR has a good balance of properties, including good chemical stability and usefulness over a wide temperature range. It is mostly applied to bond structures or different materials. To improve the performance, oil-soluble phenolic resin is added to [...]

May 19th, 2020|

NBR

This common elastomer is known by many names, Including Buna-N, NBR and Zylo Nitrile Butadine. No matter what you call it, nitrile rubber offers good resistance to oils, fuels, and chemicals. NBR`s ability to withstand a range of temperatures from -40 to 180 degrees (-40 to 220 Fahrenheit) makes it an ideal material for [...]

May 15th, 2020|

EPDM

EPDM seals and Gaskets are used widely with vehicles and equipment, but this synthetic elastomer has unsatisfactory resistance to gasoline, diesel fuel and motor oil. EPDM`s advantages are numerous, however, and this cost-effective compound is often a better choice than silicones – especially in outdoor environments. Ethylene Popylene diene monomer (EPDM) is a compound [...]

May 14th, 2020|

Bulb Seals

Bulb seals are industrial rubber products that are used to seal and insulate doors, hatches and enclosures. They fit radiused corners and have separate bulb and retainer sections, each of which can have a different durometer (hardness) and use a different material. The bulb compresses to form a seal when the door, hatch or [...]

May 14th, 2020|

NorMec Silicon Injector 501-00

To inject silicon for concrete pipes and manholes gaskets, the NorMec Silicon Injector is a perfect choice. The injection is done with the use of needles, one set of needles on each side of the join. We know time is money therefore have we designed the injector with usability as the top priority. The [...]

May 14th, 2020|

Fully automated guillotine cutter

Fully Automatic cutter for precision cutting of profiles for vulcanizing. The new fully automated cutter can be used inline in the extruder line or offline. The cutter is equipped with servo engines, caterpillar and excenter for the cutting knife. It can be equipped with a 100 mm or 200 mm wide cutting knif [...]

December 4th, 2019|

K 2019 Trade Fair

16-23 October 2019 it happens again in Düsseldorf, Germany. Visit us in hall 3 stand A35. K2019 is the largest exhibition for the plastic and rubber industry in Europe and in 2016 attracted 222,000 trade visitors from over 110 nations and as always NorMec will present and show our newest machines. We are very [...]

August 30th, 2019|

K 2019 Trade Fair

16-23 October 2019 it happens again in Düsseldorf, Germany. K 2019 is the largest exhibition for the plastic and rubber industry in Europe and in 2016 attracted 230,000 trade visitors from over 160 nations, as always NorMec will present and show our newest machines. Visit us at both A35 Hall 3. See you all [...]

April 26th, 2019|